Osha Hard Hat Requirements Roofing

Osha standards regarding hard hats osha has two standards governing hard hat requirements both in the code of federal regulations cfr title 29.

Osha hard hat requirements roofing.

1926 100 hard hat testing and certification requirements when the hard hat bill is worn to the rear. Class e electrical hard hats are rated for 20 000 volts. Osha s general industry and construction head protection standards 1910 135 and 1926 100 respectively do not require workers to wear hard hats when there is no risk of head injury. They replace the support strap annually.

Most replace their hard hats every 5 years. However even where there may not be an osha requirement to wear head protection numerous employers require 100 percent hard hat use as a company policy. Osha hard hat replacement requirements must be considered when hats bear cracks dents penetration or even wear from rough care and treatment. This may seem extreme but failure to provide your roofers with the required personal protective equipment ppe could result in a preventable injury on the jobsite and an investigation from osha.

Class c conductive hard hats do not offer electrical protection. The following information must be marked inside the hard hat. An osha hard hat expiration date does not exist but manufacturers may set a specific date for expiration. 04 17 2002 1926 100 hard hats are not required where there is no exposure to head injuries.

In your scenario where no work is being performed overhead and there is no employee exposure to possible head injuries there is no osha requirement that hard hats be worn while on the roof. You ask about requirements in the construction personal protective and life saving equipment provisions 29 cfr part 1926 subpart e with specific regard to hard hats and or eye protection. Osha will deem any head protection device that the employer demonstrates is at least as effective as a head protection device constructed in accordance with one of the consensus standards identified in paragraph b 1 of this section to be in compliance with the requirements of this section. Class g general hard hats are rated for 2 200 volts.

They do not prohibit employers from adopting more stringent requirements. This is in response to your fax dated september 6 2004 to the directorate of construction of the occupational safety and health administration osha. A universal hard hat policy is common on construction sites where workers work on roofs as well as other areas of the jobsite. Hard hat or no hard hat safety must take priority on a roofing jobsite.

Every hard hat conforming to the requirements of ansi z89 1 2014 must be appropriately marked to verify its compliance. According to the ansi isea standard hard hats must also contain user information such as instructions pertaining to sizing care and service life guidelines.