Brakeware brake cable c11660.
Parking brake cable adjuster enabling.
Enable the parking brake cable adjuster.
Save money by using the cable shortener instead of replacing the entire cable.
The adjustment bolt will be located on the parking brake lever.
Two technicians are required to perform this procedure.
Restores tight firm feel when pulling up the emergency brake handle.
If the parking brake feels weak then the parking brake cable may need to have its tension adjusted.
Attempt to rotate the rear tire and wheel assemblies.
The parking brake lever can be foot actuated and mounted to the driver s left or hand actuated and mounted at the driver s right in the center console.
It s constructed from high quality materials for long lasting service.
One inside the vehicle and one outside the vehicle.
Adjusting the parking brake.
Raise and support the vehicle.
Get free next day delivery or pick one up in store today.
This bolt tightens the cable leading to the rear brakes.
Except push to release parking brake pedal.
Raise and support the vehicle so the tire and wheel assemblies are clear of the ground.
Raise the park brake lever.
Lift the park brake lever boot to gain access to the multiplier lever at the front of the park brake lever assembly.
Adjust the parking brake.
Rely on your parking brake again and switch out that brake cable.
1 year warranty 22.
Disabling the park brake cable automatic adjuster before any components of the parking brake system are serviced the following procedure must be followed.
A parking brake cable can stretch rust or seize due to wear.
This may cause the emergency brake to not operate.
Either under the car about midway between the front and the rear or attached to the parking brake lever.
69 3 in rear drum brakes.
If your parking brake cable has been damaged o reilly auto parts carries replacement parking brake cables for most vehicles.
Park 2 of 3.
The brake cable adjuster is usually located in one of two different places.
The wheels should not rotate forward.
Pivot the lever up and down 3 times.
Place the transmission in neutral.
To enable after component replacement to reengage the the automatic adjuster complete the sequence below.
Our parking brake cable shortener is engineered to effectively take up excess slack in cables.
Check the brake by pulling the lever up and feel for tightness.
Cycle the park.